Electric Soundcards for large scale, outdoor railways in G scale, Gauges 1 and 3 and ride on railways.
MyLocoSound Universal is physically smaller than its predecessor, it retains the installation simplicity of screw terminals and also the same low price. However the quality and variety of sounds has been improved. A bell, a guardís whistle, airbrake release, brake compressor, door slam and "All aboard" are all included.
Three styles of horn are included. For British locos there is a two tone horn and also the older air horn. For other countries there is a generic horn. On all of them the pitch and volume is adjustable using our TV remote control.
Three motor sounds are included; two of them conventional and the third being the musical notes of the German Taurus. All vary realistically as the locomotive speeds up and slows down.
Previous MyLocoSound products have used purely synthesised sound to produce a low cost soundcard which is readily adjustable. To achieve greater realism, but still at the low price, MyLocoSound Universal uses a blend of recorded sounds from actual locos with the adjustability of synthesised sound.
Whilst itís great to have a highly adjustable soundcard, the benefit is lost if you have to take the locomotive apart each time you want to make an adjustment. MyLocoSound has solved this problem by providing a handheld remote control which is used to make all adjustments from outside the locomotive. These are Sony compatible TV remote controls which can be purchased from local consumer electronics stores or from MyLocoSound at very little cost. Only one remote control is needed for any number of locomotives.
All of the sounds can be triggered by the function buttons of the Crest Revolution or the multi-channel radio control systems from RCS, Peter Spoerer, Micron, Mtronics, Mac 5, Cliff Barker, RailBoss, Airwire and others. MyLocoSound Universal also works well with simple track powered railways. On these, the sounds can be triggered in three ways. Firstly, the steam whistle can be set to sound automatically when the loco moves off and at timed intervals when running. Secondly, trackside magnets and loco mounted reed switches can trigger any of the sounds at selected positions on the railway. Thirdly the remote control can be used to trigger any of the sounds but only from short distances.
On track powered railways, each locomotive needs a nine volt support battery on board to sustain the sound when the track voltage is reduced to stop at a station. This battery will recharge automatically when the loco is running.
To find out more please download the instructions ...........